> My Printer Is Auto Bed Leveling. AUTO BED LEVELING!!!

#1 2025-11-22 03:07:12

I am printing a replacement 3M command strip bracket that goes on a shower caddy:

CIFotoDumpRandom24658141.png

CIFotoDumpRandom89280986.jpg

#2 2025-11-22 04:45:45

It's not that hard to post pictures

#3 2025-11-22 23:24:26

So, the prototype came out pretty close but there is a satisfying "click" with the original when it locks into place that I am not getting with mine. It has something to do with the little hook in the middle. On to v2.0.

CIFotoDumpRandom61884184.jpg

#4 2025-11-22 23:44:12

Know!! What dose this meen and why their printar in hevan???

#5 2025-11-23 22:30:47

The second version was a failure. The "clicking" wasn't working because the slicer was printing the locking tab in free air as I had supports disabled. For v2.0 I enabled supports under the locking tab but I basically destroyed the clip trying to remove the supports.

For v3.0 I am printing it on its side to see if that helps. At minimum the supports will be easier to remove.

Bambu?

RockHardConservative wrote:
Bambu?

Yes. X1C.

v3.0 was a failure. Not sure what I did wrong, but I didn't get any supports.

v4.0 has printed and supports are there now. Will QC it later.

CIFotoDumpRandom45127044.jpg

> My Printer Is Auto Bed Leveling. AUTO BED LEVELING!!!

My Printer Is Auto Bed Leveling. AUTO BED LEVELING!!!

Re: My Printer Is Auto Bed Leveling. AUTO BED LEVELING!!!

Re: My Printer Is Auto Bed Leveling. AUTO BED LEVELING!!!

Re: My Printer Is Auto Bed Leveling. AUTO BED LEVELING!!!

Re: My Printer Is Auto Bed Leveling. AUTO BED LEVELING!!!

Re: My Printer Is Auto Bed Leveling. AUTO BED LEVELING!!!

Re: My Printer Is Auto Bed Leveling. AUTO BED LEVELING!!!

RockHardConservative wrote:

Re: My Printer Is Auto Bed Leveling. AUTO BED LEVELING!!!